Vermeiren TRACER Mode D'emploi page 10

E
Adjust function
Seat inclination
Angle of backrest
Leg support
left
Leg support
right
Leg supports
simultaneous
Set time
By default, the factory sets the time to be visible in the status display. To change this option, proceed
as follows:
To switch back to the driving program, select the
drive profile button (8) in drive mode.
The only functions displayed in the menu selection and
In Display
Display Menu
the centre of the display are those which exist on your
wheelchair and have been enabled.
L
L
Select the program function using the field
selection button (9) and the display will show the
menu for the special functions.
Select left/right with the joystick or the menu
selection button (10) until the time function you
want appears in the centre of the display.
If you want to set the time, confirm by moving the
joystick upwards.
The time digit waiting to be set flashes. To change
other digits, you can select left/right with the
joystick or use the menu selection button (10).
To adjust the digits, select upwards with the
joystick.
To save the new time, confirm by moving the
joystick downwards.
To switch back to the driving program, select the
drive profile button (8) in drive mode.
Select the program function using the field
selection button (9) and the display will show the
menu for the special functions.
Make sure that no objects and/or persons are
inside the swinging range of the adjust functions,
since this could cause damage and/or injury.
For your safety the adjust functions can only be
activated when all four wheels of the wheelchair
are standing still. The driver programs are
disabled while the adjust functions are active.
8
TRACER
01/2010