Johnson LIVESTRONG LS13.0T Manuel Du Propriétaire page 9

TOOLS REQUIRED:
6 mm T-Wrench (included)
5 mm L-Wrench (included)
Screwdriver (not included)
PARTS INCLUDED:
2 Console Masts
1 Console Assembly
2 Sets Console Mast Covers
2 Heart Rate Grip Bars
2 Base Frame Covers
(LS13.0T & LS15.0T only)
1 Hardware Kit
1 Safety Key
1 Power Cord
1 Heart Rate Chest Strap
(LS15.0T only)
1 USB Cover
1 Rubber Pad For Media Players
1 Audio Adapter Cable
1 Bottle of Silicone Lubricant
(for 2 applications)
NEED HELP?
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back cover
of this manual.
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Never open box when it is on its side. Once the banding straps have been removed,
do not lift or transport this unit unless it is fully assembled and in the upright folded
position, with the lock latch secure. Unpack and assemble the unit where it will be used.
The enclosed treadmill is equipped with high-pressure shocks and may spring open if
mishandled. Never grab hold of any portion of the incline frame and attempt to lift or
move the treadmill.
WARNING
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
ALL
MODELS
9