4.2. Installation of the inverter
1 1
Fix two DIN rails to the mounting surface as shown
in figure 1. The position of the lower DIN rail can also
be determined by first attaching two inverters to the
upper rail.
Three fixing holes can be used if only a single unit is to
be installed (see figure ).
DC input
(Solar panel)
–
+
/
150 mm
fig. 1
2 2
Position the first inverter on the rails with the solar
panel connection terminals on top.
Slide the locking clip supplied with the unit (at the
bottom/middle of the unit) downwards.
Hang the unit into the top rail.
6
AC output
153 mm
fig.
EN
5 3 m m
2 2 8 m m
735.794 | 10.10
DIN rail
StecaGrid 300/500
DC input
(Solar panel)