Maxspect R5-100 Mode D'emploi page 16

Maintenance of the fixture
User must periodically perform maintenance on the fixture, including but not limited to the
English
following steps:
 Using a damp cloth to clean the acrylic lens to make sure it's not covered by salt creep
or other dirt and debris. Uncleaned lens will severely affect the luminous output of the
fixture, so for best performance you should clean the lens once a week.
 Clean the dust and debris trapped in the fan units. Regularly and properly cleaned fans
will last much longer than those that aren't. Fan units are wear-and-tear parts and
must be replaced every 24-36 months depends on the frequency of maintenance
performed on them.
 Clean / remove any salt creep or dirt and debris that had been builtup or collected on
the aluminum body of the fixture, as they may affect the dissipation of heat from the
fixture.
Note: Failure to perform the above mentioned maintenance on the fixture may cause
unnecessary damage to your fixture and may void your warranty!
Specifications
For latest specifications on LED layout, types and color spectrum, please visit our website at:
www.maxspect.com
14
Important Information