Maxspect R5-100 Mode D'emploi page 10

Understanding Time Points
There are a total of 24 Time Points. You can program different luminous output intensity at
English
each Time Point to control the photoperiod and brightness of the system.
Take Preset P1 as an example, it is a setting for SPS dominated tank. The photoperiod starts
at 08:00 where the system increases light gradually, peaks at 10:00 and lasts 10hrs to 20:00
before the system gradually decreases light until it is turned off at 22:00, with moon light
turns on.
Channel A
Channel B
Channel C
Channel D
The following diagram illustrates how the 4 LED channels would behave once the above Time
Points have been programmed.
8
TP01 TP02 TP03
08:00 09:00 10:00
0% 40% 90%
0% 20% 70%
1% 20% 70%
0% 20% 90%
Operating Instructions
TP04 TP05 TP06
20:00 20:30 21:00
90% 70% 50%
70% 30% 15%
70% 30% 15%
90% 30% 15%
TP07 TP08
21:30 22:00
25% 0%
10% 0%
10% 1%
10% 0%