Standard Cross Cuts; Mitre Cuts - Elektra Beckum KS 210 Instructions D'utilisation

Use only rubber-shielded cables
(H07RN-F 3 x 15 mm or similar).
Do not pull on power supply cable to unplug.
Operation
• Before starting work check to see that the fol-
lowing are in proper working order:
− saw blade;
− retractable blade guard;
− safety lock.
• Use personal protection gear:
− dust respirator;
− hearing protection;
− safety goggles.
• Assume proper operating position:
− at the front of the saw;
− in front of the saw;
− to the left of the line of cut.
• If the type of work requires, use the following:
− work support for long stock, which would oth-
erwise fall off the table on completion of the
cut;
− Dust collection bag or dust collector;
c
Danger! Entanglement hazard!
Do not wear loose clothing, jewellery, or
gloves, which may get caught and wound up
by the revolving saw blade.
Contain long hair with a hair net.
Never cut stock with the following attached:
− ropes,
− strings,
− webbings,
− cables or
− wires
or containing such materials.
A
Caution!
Cut only stock of dimensions that permit for
safe holding during the cutting operation.
Always hold the workpiece against the fence
and down on the table.
Do not jam workpiece.
Never cut several workpieces at the same
time – and also no bundles containing several
individual pieces. Risk of personal injury if
individual pieces are caught by the saw blade
uncontrolled.
Use appropriate jig when cutting round stock
to keep it from turning.
Do not attempt to stop the saw blade by push-
ing the workpiece against its side.
Replace a dull blade at once.
2.22

Standard cross cuts

Starting position:
− Sawhead fully lifted
(if necessary, pull out locking pin);
− Turntable locked in 0° position;
− Saw blade is in vertical position to the saw table.
1. Hold workpiece against the fence.
2. Depress and hold down the ON/OFF switch.
3. Swing safety lock to the side and lower the saw-
head onto the workpiece.
3
For sawing exert only so much downward
pressure that the motor speed does not fall off
too much.
4. Cut workpiece in a single pass.
5. Release ON/OFF switch and return sawhead to
its upper rest position.

Mitre cuts

3
With a mitre cut the workpiece is cut an angle
of 0° to 45° against the rear guide edge.
Starting position:
− Sawhead fully lifted
(if necessary, pull out locking pin);
− Saw blade is in vertical position to the saw table.
KS 210 / KS 210 HM Plus