SOLIS EASYVAC PRO Mode D'emploi page 77

Anleitung_SOLIS_Vakuumiergera?t_DE-FR-IT-GB-NL:2011
L
P R O B L E M S A N D P O S S I B L E
C A U S E S
T H E A P P L I A N C E D O E S N ' T W O R K
1. Check that the plug is plugged into the correct socket.
2. Check whether the power cable is damaged. If this is the case, bring the appli-
ance to SOLIS or a SOLIS approved service centre to get the cable replaced.
3. Check whether the socket is working by connecting another electrical device.
4. Check that the end of the bag is correctly sitting in the vacuum chamber, next
to the air extraction opening.
5. The vacuum sealer switches off automatically if it overheats. Let it cool down first
before starting to use it again.
T H E A I R I S N O T C O M P L E T E LY S U C K E D O U T
O F T H E B A G
1. So that the bag gets completely sealed, the open end of the bag must lie com-
pletely in the vacuum chamber without any wrinkles.
2. Check that the sealing bar and the seals around the vacuum chamber are free
from dirt and in the correct position. Also, the seals must not be broken or
porous. Clean the seals and the sealing bar.
3. Check whether the bag has a hole in it. To do this, seal the bag with some air
in it and submerge it in water. If bubbles rise from it, it is leaking, use another
bag.
4. Use bags and films from SOLIS exclusively!
5. Perhaps the bag is not completely sealed, because of crumbs, fat or liquid in the
seal or the bag was not flat and has wrinkles or creases. Open the bag, clean
the end of the bag inside and out, the sealing bar and the seal and make sure
that the end of the bag is lying completely flat in the vacuum chamber.
T H E A P P L I A N C E D O E S N O T S E A L
A F T E R VA C U U M I N G
1. In the appliance there is a vacuum pressure sensor. If the pressure is not high
enough, the sealing pressure will not automaticallly start. Check the sealing bar
and the seals for contamination and clean if necessary. Also check that they are
in the correct position and start the appliance again.
2. Check whether the seals are broken or twisted. Put them back in place or replace
them with new ones - SOLIS or your nearest SOLIS-service station can help you
further.
02.11.2011 11:31 Uhr Seite 77
77