SOLIS EASYVAC PRO Mode D'emploi page 71

Masquer les pouces Voir aussi pour EASYVAC PRO:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Anleitung_SOLIS_Vakuumiergera?t_DE-FR-IT-GB-NL:2011
L
T I P S F O R O P T I M A L VA C U U M I N G
1. Do not overfill the bag. Always leave enough empty space at the end of the
bag so that it can be placed in the vacuum chamber without problem and with-
out wrinkles or creases.
2. The open bag end should not be wet, since wet bags can not be sealed.
If the food contains moisture, or the bag is wet inside, choose the "Moist" func-
tion using the "FOOD" button, so that the sealing time is increased and the seal-
ing result is better.
3. Clean the open bag end and pull it straight, before you seal it. Make sure
that there is no food residue on the end of the bag and that there are no creases
in the end of the bag. The sealed seam must be completely smooth, otherwise
it will not be airtight.
4. Never leave too much air in the bag. Press on the bag a little to get most of
the air out before vacuuming. Too much air in the bag means more work for the
vacuum pump, which could overload the motor. The consequence could be that
not all of the air is vacuumed out of the bag.
5. Please do not vacuum foods with sharp edges, such as e.g. fish bones and
mussels. The sharp edges can cut through the film so that it is no longer airtight.
To vacuum such foods we recommend using a container instead of a plastic bag.
Alternatively you can cover the sharp edges and ends with folded kitchen
paper so that it cannot damage the bag or poke holes in it.
6. You should wait for a minute after every vacuum programme before you
vacuum the next bag, so that the appliance can cool down.
7. If the necessary vacuum pressure has not been reached after one minute,
the appliance will switch off automatically. If this happens, please check if the
bag/container is not airtight or whether the end of the bag is not clean and
straight in the vacuum chamber or whether there is another possible reason.
8. Always check whether the ring seals on the vacuum chamber are dirty or have
deformations or cracks. If the former is the case, clean and dry the ring seals,
if the latter is the case, replace the seals with new ones.
9. During the vacuum programme, small quantaties of liquids, crumbs or food par-
ticles can be accidentally sucked into the vacuum chamber, cloggin up the vac-
uum pump and damaging your appliance. To avoid this, we recommend first
freezing juicy or moist foods, before you vacuum them in the bag, or place
folded kitchen paper to form a barrier. For powdery or finely ground foods the
following applies: do not overfill the bag and place a coffee filter in the bag
before vacuuming the bag.
10. In gereneral fruits should be pre-frozen and vegetables blanched before
vacuuming in order to achieve best results.
02.11.2011
11:31 Uhr
Seite 71
71

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

569

Table des Matières