Sawing With The Adaptation Table - Festool CARVEX PSC 420 EB Guide D'utilisation

Sawing with the adaptation table

WARNING
Risk of injury

Always disconnect the battery pack before in-
stalling the adaption table!
The adaptation table ADT-PS 400 is used for fitting
your jigsaw on the Festool guide rail and the circle
cutter KS-PS 400.
9
Attention: Only use with
materials thinner than
20mm and cross-set sawblade!
With guide rail and circle cutter: do not ex-
ceed max. material thickness of 20 mm and
always use cross-set saw blades (FSG).
Installing the adaptation table

Remove the saw table [1-10], (see chapter ).

Mount the adaptation table [9-1] on the saw ta-
ble support.

Close the change lever [1-8].
Ensure that the adaptation table is firmly seated in
the guide.
 Use the extractor connector [1-7] also with the
adaptation table.
Adaptation to the guide rail FS 2
The Festool guide system FS 2 (Fig. [10]) makes it
16
much easier to manufacture straight precision
cuts.

ADT-PS 400
9-1
Adaptation to the circle cutter
The circle cutter can be used to create circular cuts
with a diameter between 120 and 3000 mm. The cir-
cle cutter can be installed from both sides on the
adaptation table.
KS-PS 400
KS-PS 400
12-1
11-1
Place the jigsaw with attached adaptation table
[9-1] on the guide rail.
12-5 12-4
11-5 11-4
10 11
11
12
12-2
11-2
12-3
11-3