Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.2 Assembly
1. Place the base unit (8) on a flat surface, e.g. a kitchen counter, and make sure it is standing
firmly.
2. Push the collection tray (5) into the base unit and ensure that the handle end faces outwards.
3. Install the chosen attachment into the holder, depending on what you are going to use the
appliance for (see the section about the individual attachments below). Turn the holder so that
the pin on the small handle faces upwards. Place the attachment in the holder so that the small
round hole in the attachment fits over the pin on the left side of the holder.
4. Place the holder with the installed attachment onto the base unit so that the rollers rest in the
inside edge. The end with the small handle should be placed in the furthermost end of the base
unit.
5. Place the lid (6) onto the base unit whilst ensuring that the slit in the lid fits over the pin on the
holder's small handle. Press the lid until it clicks into place. Using a finger, check whether the
holder can be moved freely back and forth.
6. Install the motor unit (9) above the lid, so that it fits down over the pin in the slit and the two
pins at the top of the lid.
7. Decide whether to use the large (7), medium (3) or small (2) feed tube, depending on the size of
the vegetables you are going to chop/ slice. Select the corresponding pusher that matches the
size of the feeder opening. See explanation in the table below.
8. The locking ring (4) fixed around the medium-sized feed tube is equipped with a tongue that acts
as an off button. The tongue should be fitted into the recess around the activation pin (10) on
the motor unit before the appliance can be started. The appliance is designed so that this part is
always used, either as a feed tube or as a part of the large pusher.
9. The appliance is now ready for use.
Feed tube
Large feed tube (80 mm diameter)
Medium feed tube (60 mm diameter)
Small feed tube (40 mm diameter)
PLEASE NOTE
NEVER put fingers, utensils or similar into the feeding pipe or collection tray whilst the
appliance is in use.
NEVER use fingers, kitchen utensils or similar to push ingredients down the feed tube. Always
use the pusher.
NEVER touch the moveable parts whilst the appliance is switched on or connected to the
mains.
5.3 The grater attachment
The grater attachment (12) is intended for grating vegetables and cheese. We recommended using
the appliance with hard chesses, such as parmesan. Soft cheeses are not very well suited for grating.
1. Install the grater attachment into the holder and install the holder onto the appliance.
2. Install the lid and motor unit onto the appliance.
3. Connect the appliance.
4. Select the feed tube that corresponds to the size of the foods to be grated.
5. Cut the cheese or vegetables into long sticks, and place the sticks in the feed tube.
6. Ensure that the tongue on the locking ring fits down into the recess around the activation
pin.
To be used with
Large pusher (= medium feed tube + small feed
tube + small feeder) (1+2+3)
Medium pusher (= small feed tube + small
pusher (1+2)
Small pusher (1)
35
Publicité
Table des Matières
