Transport And Storage; General; Storage; Transport - Sera CVD Série Mode D'emploi

Systèmes de dosage – construction verticale
CVD 1 (s) / CVD 2
Notice d'utilisation

Transport and storage

4.1

General

Before shipment sera products are checked for proper condi-
tion and functioning.
The products are packed according to the transport conditions.
The system is transported horizontally.
The customer has to check the product for transport damage
immediately after receipt. Any damage detected is to be re-
ported immediately to the responsible carrier and the supplier.
The unit should only be transported using suitable means of
transport or hoists. Pay attention to the weight of the system
and the carrying capacity of the means of transport.
4.2

Storage

An undamaged packaging protects the unit during subsequent
storage and should only be opened just before the system is
installed.
Proper storage increases the service life of the unit and pro-
tects from negative influences such as heat, humidity, dust,
chemicals etc.
The following storage instructions are to be observed:
•
Storage place: cool, dry, dust-free, no exposure to direct
sunlight, and slightly ventilated
•
Storage temperatures between +2℃ and +25℃
•
Relative air humidity not more than 50%.
If these values are exceeded, metal products should be air-
sealed in foil and protected from condensation water with a
suitable desiccant.
Do not store solvents, fuels, lubricants, chemicals, acids, disin-
fectants and similar in the storage room.
4.3

Transport

CAUTION !
The accident prevention regulations must be observed for
transport!
CAUTION !
Keep a sufficient distance from high-tension lines when
transporting the system
CAUTION !
Check the system for loose parts.
Secure loose parts for transport!
Sous réserve de modifications techniques !
32
Subject to technical modifications!
The unit should only be transported using suitable lifting gears.
Example:
Lift by means of a tie-bar (not included in the scope of supply).
Lead the carrying belts through the transport holes and lift.
CAUTION !
Be careful when lifting the system. Pay attention to the
center of gravity! Fasten the system sufficiently!
Lifting eyes
Fig. 02 Transport (e.g. with tie-bar)
CAUTION !
Do not place the system on the collecting basin while
working!
If this note is not observed, the drain plug of the collecting
basin may break off.
www.sera-web.com
TA450-11 / fr/en /01.2017 / PM