Jotul F 470 Série Manuel D'installation Et D'utilisation page 9

4.2 Installation
Base, pedestal and leg
Only for base
Fig. 4
Through the floor
1. NB! If connecting the Flex Hose through a hole in the floor, do
not knock out the removable cover plates (Fig. 4 A).
Through the rear outlet in the base
2. If attaching a Flex Hose (Ø 100 mm) for external air supply to
the external air connector (Fig. 4 B) beneath the burn chamber,
first drill a hole in the removable cover plates (Fig. 4 A) before they
are knocked out. Let the inner plate inside the base remain
in place when the cover plates are knocked out. Then remove
the shelf and inner plate in the base.
Fig. 5
3. Carefully lay the stove down on its back. Rest the stove on a
pallet and three packaging frames.
Fig.6
Fig. 7
4. Remove the two screws for installation of the sides (Fig. 6 A).
5. Push the base up to the burn chamber (Fig. 7) and secure
it firmly with the four screws (M8 x 25 mm) and washers
provided. See Fig. 6 B.
Fig. 8
6. Loosen the height adjustment screws slightly (Fig. 8 A)
beneath the product so that they can be screwed by hand.
ENGLISH
9