Jotul F 470 Série Manuel D'installation Et D'utilisation page 22

ENGLISH
Adjusting the door – lower section
Fig. 33
1. Pull the door handle out (Fig. 33 A).
2. Loosen the check nuts (Fig. 33 B).
3. Push the door to the position required and hold it there while
tightening the check nuts (Fig. 33 B).
4. If the door is stiff after it has been adjusted, close the door,
loosen and tighten the screws in Fig. 30 - II C.
22
Fig. 34 - 1
Fig. 34 - 2
Lower the door
1. Loosen the check nut (Fig. 34 - 1 A) and unscrew the screw B.
2. Pull the door handle out (Fig. 34 - 2 A).
3. Loosen the check nut (Fig. 34 - 2 B).
4. Adjust the height with the screw (Fig. 34 - 2 C).
5. Tighten the check nuts (Fig. 34 - 2 B).
6. Mount the screw and check nut (Fig. 34 - 1) so that the screw
head touches the top plate when the door is fully closed.
Raising the door
1. Pull the handle out (Fig. 34 - 2 A).
2. Loosen the check nut (Fig. 34 - 2 B).
3. Screw in the screw (Fig. 34 - 2 C) slightly more than the door
should be raised.
4. Loosen the check nut (Fig. 34 - 1 A).
5. Lower the screw (Fig. 34 - 1 B) as much as the door should be
raised and then tighten the check nut (Fig. 34 - 1 A).
6. Close the handle and lower the screw (Fig. 34 - 2 C) until it
meets the handle. Then tighten the check nut (Fig. 34 - 1 B).