Dimplex FPE 050E Instructions De Montage Et D'utilisation page 21

FPE 050E - FPE 200E
Blocking
Press and hold the + key and – key simultaneously
for approx. 10 seconds.
CLEF 1 and the BLOCK symbol are shown after
3 seconds. After approx. 7 seconds, CODE
flashes. The BLOCK symbol is shown.
Press the MANUAL key. The first CODE digit
flashes.
Set to the desired code digit with the + / – keys:
Press the MANUAL key. The second CODE digit
flashes.
Set to the desired code digit with the + / – keys:
Proceed in the same way for all 4 code digits.
Confirm with the MANUAL key. The BLOCK
symbol is shown.
Unblocking
Press and hold the + key and – key simultaneously
for approx. 3 seconds. CODE display flashes.
Press the MANUAL key. The first CODE digit
flashes.
Enter the first code digit with the + / – keys.
Press the MANUAL key. The second CODE digit
flashes.
Enter the second code digit with the + / – keys.
Proceed in the same way for all 4 code digits.
Confirm with the MANUAL key. If the code was
entered correctly, the OK display
The BLOCK symbol disappears.
NOTE
If the code was entered incorrectly, the NON display
flashes.
www.dimplex.de/en
10.5
Press the WINDOW and AUTOMATIC OPERATION
keys briefly at the same time. The current time is
shown briefly.
Incorrect time display
An extended interruption in the power supply can result
in an incorrect time display.
Re-setting the time
flashes.
10.6
Constant
approx. 10 seconds.
1802/A
Displaying the current time
NOTE
Press the + key The hours display flashes.
Use the + / - keys to set the hours.
Press the MANUAL key. The minute display
flashes.
Use the + / - keys to set the minutes.
Press the MANUAL key. The weekday display
flashes.
Use the + / - keys to set the weekday.
Press the MANUAL key to return to the main
display.
Backlighting
backlighting
of the display or limited to
Switch off the heating device.
Press and hold the MANUAL key and ON/OFF key
for three seconds. NIV2 is shown.
Press and hold the WINDOW key for three
seconds. The backlighting flashes.
English
EN-10