Problem Solution - TERMA SOA Mode D'emploi

ly set. Settings can be modified as required
while the device is working (buttons and ).
If the device was off before the timer mode
was activated, it will turn off automatically
on termination of the timer. If the device was
set to i.e. setting 2 before the timer mode
was activated, and is then modified to i.e.
setting 4, the device will return to setting
2 after 2 hours.
Attention: if the device is on and settings are
not modified on activation of TIMER, settings
will not change after 2 hours. It will still op-
erate on the same setting.
Troubleshooting
Problem
Device is connected to
electricity, no diodes are
on
Device heats despite hav-
ing been turned off with
button.
If the problem persists, please contact your local distributor
Press button at any time to stop the TIMER
mode. Turning the device off and back on
with the button
function.
Anti-freeze function
(Anti-freeze protection)
When the device is off and the temperature
around temperature sensor drops to below
6°C, the device will switch on automatically.
This is to prevent the heating medium inside
the radiator from freezing. Activating Anti-
freeze mode is indicated by flashing of the
centre diode.
Possible cause
Connection problem
Electronics problem
will also deactivate the

Problem solution

Check power lead is
plugged into power sock-
et and that power switch
is on
Disconnect the device
completely from electricity
and wait until the radiator
cools down. Turn the de-
vice back on
EN
47