Babyauto TownFix123 Notice D'instruction page 25

7. HARNESS REMOVAL. GROUP 2 & 3.
WARNING
1. To change the position of the harness you must remove the chest
straps of the harness connector from the back of the seat (7.1 &
7.2). Remember to change the position of the shoulder pads.
2. Stretch the chest tapes round the front of the seat until all the tape
is out (7.3 & 7.4).
3. Stretch the tapes below the elevator (7.5 & 7.6).
4. Remove the buckle anchors located in the elevator as shown in
image (7.7).
8. INSTALLING CHILD SEAT. GROUP 2 & 3.
WARNING
Make sure you have installed the ISOCLICK anchors before installing
the chair as indicated in Group 2 and 3.
Before installing the seat it is necessary to remove harness straps,
crotch straps and lap straps as shown in Chapter 7.
1. Place the child seat on the vehicle seat pressing against the back
of the vehicle seat (8.1).
2. Place the child in the child restraint seat with height adjuster
child's shoulders (8.2).
3. Fasten the belt, ensuring that the lap belt goes through the guide
under both armrests and that the diagonal shoulder belt passes
through I height adjuster on the childrens shoulder and under the
armrest that is next to the vehicle anchor point. Fasten the seat
belt into the vehicle´s buckle until it "clicks", making sure the child
seat is properly installed (8.3, 8.4, 8.5 y 8.6).
4. Make sure the vehicle's safety belt is not twisted, also check that
the seat cover does not impede the movement of the vehicle seat
belt or prevent the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as described in the
instructions.
Group 1/2/3
Use Group 2 & 3 only from approx. 4 to 12
years of age (15-36 kg)
Use Group 2 & 3 only from approx. 4 to 12
years of age (15-36 kg)
I at the
www.babyauto.com www.babyauto.com
EN
25 25