Getting Started - Ribimex Ribiland PRMPP043 Traduction Des Instructions D'origine

As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is
necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an
increased danger of early piston seizing due to abnormally lean mixture.
5. Put a clear indication on the outside of the container to avoid mixing up with gasoline or other
containers.
6. Indicate the contents on outside of container for easy identification
3.4.4- Fueling the unit
1. Loosen and remove the fuel cap. Rest the cap on a clean and
dustless place.
2. Put fuel into the fuel tank to 80% of the full capacity.
Do NOT refill above filter level.
3. Fasten the fuel cap securely and wipe up any fuel spillage
around the unit.
WARNING: 1. Select bare ground for fueling.
2. Move at least 10 feet (3 meters) away from the fueling point
before starting the engine.
3. Stop the engine before refueling the unit. At that time, be sure to sufficiently
agitate the mixed gasoline in the container.
3.4.5- To preserve your engine life, avoid:
1. Fuel with no oil (raw gasoline): it will cause severe damage to the internal engine parts very
quickly.
2. Gasohol: it can cause deterioration of rubber and/or plastic parts and disruption of engine
lubrication.
3. Oil for 4-cycle engine use: it can cause spark plug fouling, exhaust port blocking, or piston ring
sticking.
4. Mixed fuels which have been left unused for a period of one month or more may clog the
carburetor and result in the engine failing to operate properly.
5. In the case of storing the product for a long period of time, clean the fuel tank after rendering it
empty. Next, activate the engine and empty the carburetor of the composite fuel.
6. In the case of scrapping the used mixed oil container, scrap it only at an authorized repository
site.
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Hose assembly
Important: use only a PVC suction ringed hose or other hose with similar quality (not included).
not supplied.
Note: the hoses are
Assemble the intake hose joint and the intake hose (suction hose) to the water pump.
- 21 -