Ribimex Ribiland PRMPP043 Traduction Des Instructions D'origine page 22

6. Stop the motor immediately if the product suddenly begins to vibrate or shake. Inspect for
broken, missing or improperly installed parts or attachments.
7. Never smoke or light fires near the hedge trimmer. Keep the trimmer away from excessive heat.
Engine fuel is very flammable and fire could lead to serious personal injury or property
damage.
8. Make sure of no fuel leaking from Fuel tank, Fuel cap, Fuel pipe and Carburetor and other parts
which fuel may leak. Repair the machine if fuel leaking, make sure no leaking again.
9. Don't get product close to inflammable materials such
as ropes, dead leaves, waste paper and oilcloth etc.
10. After refueling, screw the fuel cap back tightly onto
the fuel tank and then carry the product to a spot 3m
or more away from where it was refueled before
turning on the engine.
11. Refueling
➢ Never store cans of fuel or refill the fuel tank in any place where is a boiler stove, wood fire,
electrical sparks, welding sparks or any other source of heat or fire which might ignite the fuel.
➢ Don't smoke when handling the fuel.
➢ When refilling the tank, always turn off the engine first and take a careful look around to make
sure that there are no sparks or open flames anywhere nearby before refueling.
12. If any fuel spillage occurs during refuelling, use a dry rag to wipe up spills before turning the
engine back on again.
13. Do not transport this unit on an uneven surface of the road for a long time when the fuel tank is
full. This may cause fuel spillage after the tank cap is loosened as a result of bumping and
impacting.
14. Before starting engine, keep children and animals out of the working area.
15. Never touch the muffler, spark plug and plug wire while the engine is in operation or
immediately after stopping the engine. Doing so could result in electric shock and/or serious burns
because of high temperature.
16. For safe operation, use caution and keep the children away from the spot where the engine is in
operation.
17. The working temperature should be within 5C and 60C. Otherwise; the pump is easy to get
damage.
18. Never use the pump without water in it. Doing so could result in serious damage of the pump.
19. Be sure to use a suction hose (not included).
Please use hose buckles and hose tape (not included) when connecting the suction hose (not
- 19 -