Ribimex Ribiland PRMPP043 Traduction Des Instructions D'origine page 30

3. Refill the pump with water and start the engine. Keep it running at low speed until the fuel is
used up.
4. Remove the spark plug and refuel 1-2cc of motor oil for 2-cycle engine into the cylinder. Pull out
the hand starter 2-3 times.
5. Replace the spark plug as it was and pull the starter. Release the starter grip at the position where
you feel it hard to pull.
6. Drain off the water in the pump thoroughly and wipe out the water with a rag
7. Before storing the machine, repair or replace any worn or damaged parts.
8. Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water.
Rinse and dry thoroughly, then add a few drops of oil and work it in. Reassemble.
9. Store the machine in a clean, dust-free area.
Product must be stored in a dry location. Always lock up product and keep out of reach of children.
6.4- Disposal
When disposing of your machine, remove oil and fuel from the machine, and be sure to follow the
local regulations. Do not dispose of in/with household rubbish.
6.5- Troubleshooting
Phenomena Cause
The starter rope The wheel of the starter lead
cannot be pulled is struck or blocked by other
out. things.
The crankshaft The engine is burnt or
is not running. blocked by other things.
The fuel is inferior.
(Impurity, regenerated)
The fuel is sucked too much
The muffler exhaust
The damage, short circuit,
The engine
and breakage if the spark
cannot be
plug electrode
started.
The blockage of the
carburetor
The damage of the piston
and the cylinder
The breakage and short
circuit of the coil
Lack of water in the pump
Looseness of the joint of the
suction hose
Inferior buckles at the joint
No suction of the suction hose
Cracking and damage of the
suction
Bent drainpipe, the valve is
locked.
Handling method
Disassemble and repair (Competent servicing dealer)
Disassemble the engine and replace the damaged parts
(Competent servicing dealer)
Replace it.
Turn on the throttle fully and pull the starter continuously.
Clean it.
Clean the electrode or replace the spark plug. Check and
replace the circuit.
Disassemble and repair the carburetor. (Competent
servicing dealer)
Disassemble and repair the engine. (Competent servicing
dealer)
Replace. (Competent servicing dealer)
Supply water.
Don't let air in when installing.
Replace a quality-proven one. (Competent servicing
dealer)
Replace a quality-proven one. (Competent servicing
dealer)
Straighten the bent part and turn on the valve.
- 27 -