Operation; Setting; Basic Setting - Conrad Electronic WS 9624-IT Mode D'emploi

B) LC display and settings
If the signal of the outside area is successfully received, then this symbol is displayed
(if reception is unsuccessful, the symbol is not visible). Thus it can be seen whether the
last reception attempt was successful (ON symbol) or unsuccessful (OFF symbol). A
reception currently taking place is indicated by rapid flashing of the symbol.
In order to be more distinguishable, the LC display is divided into six sections (from top to bottom) by
means of horizontal bars.
Section 1 - Time and date
• Time and date display (display seconds by pressing the "+" button).
Section 2 - Indoor temperature and humidity
• Indoor temperature display "INDOOR"
• Humidity display "HUMIDITY"
Section 3 - "Weather boy" symbol
• Display of the current temperature conditions. Depending on the current outdoor temperature,,
different weather symbols is shown (indicated by a weather boy).
• Weather forecast
Section 4 - Outdoor temperature and humidity
• Outdoor temperature display "OUTDOOR"
• Humidity display "HUMIDITY"
Section 5 - Display symbols
•
Display symbol of the transmitter "TX"
• Display symbol of the receiver "RX"
• Display symbol "Min" "Max" (for temperature)
Section 6 - Outdoor temperature and humidity
• Display of minimum and maximum temperature values
Display window of the outdoor transmitter (no picture)
• Outdoor temperature display (alternating)
• Humidity display (alternating)
28

7. Operation

7.1. Settings
A) Basic setting
The receiver can receive up to three transmitters. However, only one is included in the delivery
of this product.
Use of an outside transmitter
1. First, insert the batteries into the outside temperature transmitter (see „Installation and
replacement of batteries in the outside temperature transmitter").
2. Insert the batteries into the weather station at the latest within 25 seconds (see „Installation and
replacement of batteries in the weather station"). Once the batteries are inserted, all display
elements of the LC display then become visible briefly. Subsequently the time is displayed as
0:00 and the weather boy symbol is displayed. If there is no display within 60 seconds, then
remove the batteries and insert them again after a period of at least 10 seconds.
. After insertion of the batteries, the weather station begins to receive data from the outside
transmitter. The temperature of the outside area and the signal reception symbol should now
be displayed on the weather station. If this does not happen within  minutes, then all batteries
have to be removed and a new basic setting from Step 1 has to be undertaken.
4. To ensure a sufficient 868 MHz signal transmission, it is necessary to maintain a distance of
no more than 100 meters under good conditions between the final installation locations of
the weather station and the outside transmitter (see note under „Placement" and „868 MHz
reception").
Using more than one outside transmitter
1. If the original basic setting was undertaken with only one outside transmitter, then the user
should remove all batteries from the weather station and wait at least 60 seconds.
2. Then insert the batteries into the first outside transmitter.
. Within 25 seconds after activation of the first outside transmitter, insert the batteries into
the weather station. Once the batteries are inserted, all display elements of the LC display
become visible briefly. Subsequently the time is displayed as 0:00 and the weather boy symbol
is displayed. If there is no display within 60 seconds on the LC, then remove the batteries and
insert them again after a period of at least 60 seconds.
4. The temperature of the first outside transmitter (Channel 1) should now be displayed on the
weather station. In addition, the signal reception symbol should be displayed. If this does not
happen within 2 minutes, then all batteries have to be removed from both units and a new
basic setting from Step 1 has to be undertaken.
5. After the temperature data from the first outside transmitter is displayed on the weather
station, insert the batteries into the second outside transmitter.
The batteries should be inserted into the second transmitter at the latest within 10
seconds after reception of outside area data from the first transmitter.
29