Installation; Operation; Maintenance - Vortice THERMOLOGIKA Notice D'emploi Et D'entretien

ENGLISH

Installation

NB
Thermologika must be installed in a horizontal position,
or angled at no more than 30°.
1. Loosen the screws (C) on the pivot (fig.1).
2. Remove the cover from the wall bracket (D) (fig. 2).
Tilt the top of the appliance downwards and mark
the position of the fixing holes (diam. 7 mm) to be
drilled in the wall at a distance of 220 mm. Take care
to respect the minimum installation distances shown
in figures A and B. Drill the holes and fit the
expansion plugs provided.
3. Insert the power cable through the gland provided.
The conductors of the cable must be of no less than
1 mm 2 section and clad in an insulation sheath of no
more than 14 mm diameter;
take out the terminal block with care;
connect the cable to the terminal block F, matching
the wires correctly (L, N,
reposition the terminal block in its seat and secure
the cable with the clamp H; a watertight seal is
ensured by tightening the outer nut G
4. Close the cover D of the wall bracket, taking care to
position the cable gland correctly. Tighten the gland.
5. Pivot Thermologika to point towards the area to be
heated. (Maximum angle from the vertical is
approximately 30°.) Take care not to point the
radiating elements directly at walls, curtains, or
other flammable objects or materials. Tighten the
pivot locking screws (C) (fig. 4).
6. REMOTE CONTROL:
If you want to control Thermologika via an external
switch of suitable capacity, you are recommended to:
a. set the operating power with the cord switch;
b. remove the cord;
c. install the appliance on the relevant wall and
connect it electrically.
WARNING: It must be care of the installer selecting the
correct ratings of the Remote control switch or Relay
according to the number of the connected units.
Thermologika is now ready for use.

Operation

Pull on the pull-cord at the right of the appliance to
switch Thermologika on. This switch also selects the
heating power as follows:
Position "0": OFF
Position "1": 600 W
Position "2": 1,200 W
Position "3": 1,800 W
The status of the appliance and the current power
setting are shown in the window over the switch.
NB
When Thermologika is switched on, a slight buzzing is
sometimes produced by the quartz lamps. This is
normal and disappears after a few seconds. This in no
way affects the duration or performance of the
appliance.

Maintenance

Thermologika does
);
not require any special
maintenance. Whenever necessary, wipe off any dust
from the outside with a soft dry cloth. Slightly damp the
cloth with water and neutral detergent to remove
stubborn dirt. Take special care under these
circumstances to avoid all contact with the quartz
lamps.
NB
Disconnect the appliance from the mains supply before
performing any maintenance.