Installation; Operation; Maintenance - Vortice THERMOLOGIKA DESIGN Notice D'emploi Et D'entretien

ENGLISH

Installation

Fig. 3 ÷ 24.
NB
two types of electrical connection are possible:
for pull cord operation: fig. 17,19, 20 (wiring diagram:
fig. 21)
for external remote switch operation: fig. 17A, 19A,
20A (wiring diagram: fig. 21 A)
WARNING: It must be care of the installer selecting
the correct ratings of the Remote control switch or
Relay according to the number of the connected units.
NB
Thermologika Design must be installed on vertical
walls in the position shown in (fig.2a-15,24).
NB
The wiring compartment of the product houses a
plastic protection (fig. 20 - 20A).
This protection must not be removed for safety
reasons.
NB
We strongly recommend using Crimping Ferrules for
the terminations of electrical wiring to be connected to
the terminal board (Fig. 19 - 19A)

Operation

Thermologika Design is switched on using the pull
cord on the right-hand side of the appliance; this
device can also be used to select the desired
operating power level:
"0" position: appliance OFF fig. 25 A
"1" position: 600 W fig. 25 B
"2" position: 1,200 W fig. 25 C
"3" position: 1,800 W fig 25 D
The appliance status and the current power setting
are shown in the windows to the right of the logo.
NB
When Thermologika Design is switched on, a slight
buzzing is sometimes produced by the quartz lamps.
This is normal and disappears after a few seconds.
This in no way affects the duration or performance of
the appliance.

Maintenance

Thermologika Design does not require any special
maintenance. Whenever necessary, wipe off any dust
from the outside with a soft dry cloth. Slightly damp
the cloth with water and neutral detergent to remove
stubborn dirt. Take special care under these
circumstances to avoid all contact with the quartz
lamps.
NB
Disconnect the appliance from the mains supply
before performing any maintenance.
7