Status Led Function; Audio Warning Tones - Team Orion dDrive Mode D'emploi

STATUS LED FUNCTION

• In the neutral position, no LED are lit.
• The red LED lights when the car is moving forward,
backwards or when braking.
• At full throttle the green LED is lit.

AUDIO WARNING TONES

1. Input voltage problem: ESC checks the input voltage as
it is switched on, if a problem is detected, the ESC emits
repeatedly two beeps with a 1 second pause and the
green LED flashes simultaneously (xx-xx-xx).
2. Radio signal problem: ESC checks the radio signal input as
it is switched on, if a problem is detected, the ESC emits
repeatedly a beep with a 2 second pause and the green
LED flashes simultaneously (x-x-x).
ESC ADVANCED SETUP
You can adjust certain parameters by using the SET button
located on the ESC's switch. To adjust the parameters, follow
the procedure below.
A. Switch on the ESC.
B. Press the SET button and release it when the green LED
starts flashing.
C. Use the SET button to cycle between the various
adjustable parameters. The number of green flashes
indicates the parameter, one flash = running mode, two
flashes = low voltage cut-off and so on. The ESC will cycle
through all the adjustable parameters in a loop.
D. Once the green LED is flashing the number of times
www.teamorion.com 11