Siebert S202 Série Manuel D'utilisation page 28

Decimal point
A decimal point can be set in menu item A.
In some operating modes the decimal point can also be activated via the data inputs.
For this purpose, you must select setting 0 (no decimal point) in menu item A.
In case of a parallel interfacing in binary code [5], the decimal point is assigned via
the inputs D19...D17 to a binary address (D19 = 2
desired digit (only for units with 25 mm character height).
In case of a multiplex control [6, 7], the decimal point is controlled via the input D4.
A decimal point set in menu item A has priority over a decimal point activated via the
data inputs.
Leading zero suppression
In menu item C can be set whether leading zeros are to be displayed or suppressed.
Display test
In menu item F can be set whether a display test is automatically carried out after
power-on.
A static display test is possible via the data input F (only for units with 25 mm
character height).
Demo operation mode
If in menu item F the setting PlAy is selected, random characters are displayed one
after another. A control of the unit is in this operation mode not possible.
Data input F
If setting Fl is selected in menu item G, an H signal on input F causes a flashing of
the display, regardless of the data on the inputs D19...D0.
If setting 8. 8 . 8 . 8 is selected an H signal on input F causes a static display test,
regardless of the data on the inputs D19...D0.
28
2 1
, D18 = 2 , D17 = 2
BAL S202 PAR M 1.0
0
) of the