Pack Contents - Polar Refrigeration CB507 Mode D'emploi

UK

Pack Contents

The following is included:
• POLAR Display Chiller
• Instruction Manual
• Shelves
G619/G211/CB507/DP288 x 3
CB509/DP289 x 4
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects
for ventilation. Increase this distance if the
obstacle is a heat source.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Fitting the Shelves
1. Place the shelf guides on either side of the
cabinet at the desired height.
2. Lower the shelf into place, slotting the rear of
the shelf into the corresponding holes. Ensure
the shelves are level.
3. Repeat for the remaining shelves.
4
CB507-CB509-G619-G211-DP288-DP289_ML_A5_v18_20190109.indb 4
Operation
Turn On (G619/G211/CB507/
DP288)
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Press the button to turn the light On or Off
as required.
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the or button to display the
required temperature.
3. Press the SET button to store the temperature.
2019/1/9 14:47