WMF BUENO Mode D'emploi page 9

Technical Data
Rated voltage:
Power consumption:
Protection class:
Safety instructions
▪ Only connect the device to properly installed earthed sockets. The wire and plug must be dry.
▪ Do not pull the connecting cable over sharp edges or clamp it. Do not let it hang down and protect
it from heat and oil.
▪ Never disconnect the mains plug from the socket by the cord or with wet hands.
▪ Stop using the appliance and/or disconnect it from the mains plug immediately if:
⋅
The appliance or mains cable is damaged;
⋅
the device is not leak-proof;
⋅
there is any suspicion of a fault after dropping the appliance or similar.
In such cases, send the appliance to be repaired.
▪ Do not place the kettle on hot surfaces, such as hot plates or similar, or near open flames. It could
melt.
▪ Do not place the device on water-sensitive surfaces. Water spray may damage them.
▪ Do not operate the device under delicate furniture. Escaping steam from boiling could damage the
furniture.
▪ Never operate the kettle unattended.
▪ Do not switch on the device without water.
▪ Take the pot for filling from the base.
▪ Only fill with clean water, not milk, coffee, etc.
▪ Do not move the device during operation and do not pull on the mains cable.
▪ Caution: the device is hot. Risk of scalding from escaping steam. Only take hold of the hot kettle from
the handle and do not open the lid when pouring.
▪ Always completely empty the pot. Do not let any residual water remain in the device for a long
period of time.
▪ The mains plug is to be pulled:
⋅
if malfunctions occur during use,
⋅
before cleaning and care,
⋅
after use.
▪ No liability is accepted for any damages resulting from misuse, incorrect operation or improper
repairs.
Claims under warranty are likewise excluded in such cases.
▪ Packaging material, such as plastic film bags, do not belong in the hands of children.
220 - 240 V~ 50-60 Hz
2400 W
I
Initial operation
Clean the inside of the kettle thoroughly before using it for the first
time. To do this, open the lid as shown in the picture.
A strainer in the pouring spout ensures that large pieces of limescale
are filtered out when pouring.
The part of the connection cable which is not required can be wound
up in the base unit.
Connect the mains plug to an earthed socket.
Fill with as much water as needed to be able to see the level on the
water level indicator, although do not go above the Max mark. Close
the lid. Only in this way will the automatic boil-stop function work
reliably.
9