Munchkin vibe MKSA0511-011 Notice D'installation page 7

How To Install
2. Insert the TurnKey Tool™ into the holes
to extend each TurnKey Mount™. Turn
clockwise to extend the mount on the
right side of the gate and
counterclockwise on the left side.
3. When they reach the walls, trace the
position of each wall cup with a pencil.
4. Retract the TurnKey Mounts™ and
remove the gate.
5a. FOR DRYWALL WITHOUT STUD/
PLASTERBOARD: Hold the wall cups in
position and mark the center with a
pencil. Then put the cup aside and drill
a 7/32" hole into the drywall at the
center mark. Insert a drywall anchor.
5b. FOR DRYWALL WITH STUD: Hold
the wall cups in position and mark the
center with a pencil. Then put the
cup aside and drill a 5/64" hole into
the drywall at the center mark.
6. Peel the backs off the sticky pads
attached to the wall cups. Then stick
the wall cups back onto the wall to fit
your pencil marks.
7. Secure the wall cups against the wall
with screws.
• FOR DRYWALL WITHOUT STUD/
PLASTERBOARD: Use screwdriver or
drill to insert screw into center of wall
cup. The screw will go through
10
2
3
5a. Drywall
7/32"
5b. Stud
5/64"
the attached sticky pad and into the wall anchor previously inserted in
step 5a.
• FOR DRYWALL WITH STUD: Use screwdriver or drill to insert screw into
center of wall cup. The screw will go through the attached sticky pad and
into the hole previously drilled in step 5b.
MOUNTING THE GATE
1. Place the gate where you want to install
it. Stand on the side of the gate with
the holes near the TurnKey Mounts™.
Insert the TurnKey Tool™ into the
holes to extend each TurnKey Mount™
Turn clockwise to extend the mounts
on the right side of the gate and
counterclockwise on the left side.
To keep the gate an equal distance within the opening, tighten
each screw a little at a time and alternate between ALL 4
CORNERS. Make sure the measurement markings on the top
2 TurnKey Mounts™ match as well as the markings on the
bottom 2 match.
How To Install
1
11