Transport And Storage; Installation; General Installation Advice - oventrop Unibox T vario Notice D'utilisation

Unibox T vario
5.

Transport and storage

Transport the product in its original packaging.
Store the product under the following condi-
tions:
Temperature -20°C to +60°C
range
Relative air Max. 95%
humidity
Particles Store dry and free from
dust
Mechanical Protected from mechani-
influences
cal agitation
Radiation Protected from UV rays
and direct sunlight
Chemical Do not store together
influences
with solvents, chemicals,
acids, fuels or similar
substances
6.

Installation

6.1 General installation advice

Note the following prior to installation:
• The lower edge of the "Unibox T vario"
must be at least 20 cm above the finished
floor.
• The front face of the "Unibox T vario" must
be level with the finished wall.
Should the wall not have been
finished, take the plaster and tile
thickness into account.
• The opening of the wall box unit must face
downwards.
• The thermostat must not be influenced by
other heat sources.
• Use the enclosed brackets to align and fix
the "Unibox T vario".
• There is a blue dot on the wall box unit. A
hole can be drilled at this location in order
to feed through a cable.
• If necessary, use an empty pipe for cable
routing.
102272380-V01.02.2020
Transport and storage
NOTICE
Risk of damage due to lubri-
cants
Seals may be destroyed by greasing
agents or oil.
f Do not use any greasing agents or
oil for the installation.
f Flush any dirt particles or grease or
oil residues out of the pipework.
f Consider the latest technical status
(e.g. VDI 2035), when choosing the
operating fluid.
1
2
3
4
5
6
7
Illust. 4: Installation cross section
(1) Block or stud wall
(2) "Unibox T vario"
(3) Plaster
(4) Pipe conduit unit (separate accessory)
(5)
Edge insulating strip (separate acces-
sory)
(6)
Screed
(7)
Protective tube (separate accessory)
23