Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Index
Air Supply
Radiation shields
Assembling and adjusting the legs
Flue collar and connection
Assembling upper covers
Removing the self closing mechanism
Removing the door
2
1. Prior to assembling the insert
2
All our products are tested according to the latest
2
European requirements and also to the Norwegian
3
standard NS 3058 and NS 3059, which include particle
3
tests. However, several European countries have local
regulations for installation of fireplaces, which change
3
regularly. It is the responsibility of the client that these
regulations are complied with in the country/region
4
where the fireplace is installed. Nordpeis AS is not
responsible for incorrect installation.
4
4
Important to check
4
(please note that this list is not exhaustive):
4
• distance from firebox to combustible/flammable
4
materials
4
• insulation materials/requirements between
4
fireplace surround and back wall
4
• size of floor plates in front of fireplace if required
4
• flue connection between firebox and chimney
• insulation requirements if flue passes through a
4
flammable wall
• an access for cleaning the appliance, the flue gas
6
connector, the chimney flue must be provided
6
6
Chimney draft
6
Compared with older models, the clean burning inserts
6
of today put significantly higher demands on the
chimney. Even the best insert will not work properly
7
if the chimney does not have the right dimensions or
7
is not in good working order. The draught is mainly
controlled by gas temperature, outside temperature, air
8
supply as well as the height and inner diameter of the
chimney. The diameter of the chimney should never
be less than that of the flue/chimney collar. For draft
requirements at nominal heat output, see technical
table
The draught increases when:
• The chimney becomes warmer than the outside air
• The active length of the chimney over the hearth
increases
• Good air supply to the combustion
It can be difficult to obtain the right draught conditions
in case the chimney is too large relative to the insert,
as the chimney does not heat up well enough. In such
cases you may want to contact professional for
evaluation of possible measures. Draught that is too
strong can be controlled with a damper. If necessary,
contact a chimney sweeper.
Attention! Adverse flue draught or adverse weather
conditions, e. g. mist, wind etc., may interfere the
necessary flue draught. This should be checked be-
fore lightening the fireplace. If there is no necessary
flue draught in the chimney, the use of the fireplace
should be avoided.
GB
Publicité
Chapitres
Table des Matières
