Protection Against Overheating - Dimplex FW 550S Instructions De Montage Et D'utilisation

ATTENTION!
Rooms can become overheated if left unattended
whilst being heated; this depends on the size of the
room, its heating requirements and the setting of the
thermostat. Persons who are not able to vacate the
room if the temperature becomes too high can thus be
placed in danger.
NOTE NOTE
The necessary heat demand for frost protection must
be met by the heating capacity of the unit and must be
determined by the specialist.

4.1 Protection Against Overheating

If the permissible temperature is exceeded, the heating
device switches off automatically. If this occurs, pull the
mains plug out and leave the device unplugged for a
few minutes so that the temperature limiter can switch
back again.
Then remove the cause, e.g. when the air grid is
blocked or covered. When the device has cooled suffi-
ciently, it can be started up again.
5. Faults
If the heating device does not give off heat, check the
following points:
Has the thermostat been set to the desired temper-
ature?
Has the overheat protection been triggered? See
chapter 4.1!
Is the fuse in the fuse box switched on?
If you cannot remedy the fault, please contact your re-
tailer.
If required, you can also address your queries to the
service hotline of Glen Dimplex Deutschland GmbH.
Tel: +49 (0) 9221 709-564
Fax: +49 (0) 9221 709-589
To process your order, please state the device type as
well as its production number (E No.) and production
date (FD). This information is listed on the type plate.
Repairs and corrective measures must only be carried
out by a qualified electrician or by your after-sales ser-
vice.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D-95326 Deutschland
Subject to modifications without prior notice
www.dimplex.de/en
6. Cleaning
To clean the device, first disconnect it from the mains
and allow it to cool down. Clean the outside of the unit
using a soft, damp cloth. Do not use scouring powder
or furniture polish as this may damage the surface.
Dust which gathers inside the device can be removed
from the outside using a vacuum cleaner.
7. Technical Data
Heat output
Connection voltage
Degree of protection
Safety class
Dimensions (W x H x D)
Weight
8. Warranty
This product is supplied with a two-year warranty ac-
cording to our terms of guarantee.
9. Spare parts
Ordering spare parts at Glen Dimplex Germany GmbH
on the Internet at:
www.dimplex.de/ersatzteile.html
10. Note on Disposal
Do not dispose of the unit with general house-
hold waste. The device must be taken to a local
waste disposal plant.
Phone number: +49 (0) 9221 709 564
Fax:
E-Mail:
www.dimplex.de/en
FW_550S_dimplex_gb · 08/51081/0 – Issue 4
500 W
1/N/PE~, 230 - 240 V
IP20
I (with protective conductor)
260 x 242 x 121 mm
1.1 kg
+49 (0) 9221 709 589
09221709589@dimplex.de
FW 550S
EN-7