Publicité
Les langues disponibles
Les langues disponibles
Battery/rechargeable battery empty
If the »battery/rechargeable battery
empty-display« lights up constantly,
this means that the battery or rechar-
geable battery used is almost fully
discharged. A regular battery must
be replaced or a rechargeable bat-
tery recharged.
The »battery/rechargeable battery
empty-display« might flash briefly in
the flashing mode; this does not indi-
cate that the battery is low.
Acoustic alarm
The acoustic alarm can be switched
on or off using the on/off button.
Reset button
Press the reset button to acknowled-
ge incoming signals. This will switch
off the flashing light and the acoustic
signal.
Retrieving the last signal
The RF blink lamp stores any signal it
has received for approx. 3 minutes.
During this time, you can repeat the
signal by pressing the reset button
again. The signal will then be indica-
ted by the signal lights. The flashing
light and the acoustic signal will not
be repeated.
14 English
Mains operation
You can also operate your RF blink
lamp via the plug-in power supply
unit. To connect the PSU, insert the
connector on the end of the PSU
cable into the corresponding socket
on the left-hand side of the device.
Then plug the power supply unit into
the normal 230 V socket in your
house.
Recharging the A-2995-0 recharge-
able battery
If there is a rechargeable battery in
the RF blink lamp while the lamp is
plugged into a power supply, the bat-
tery will be recharged.
The recharging cycle begins automa-
tically. After 12 hours, the device will
switch to conservation charging. The
device can remain plugged into the
regular power supply. The lisa devi-
ce's reception functions will continue
to operate while recharging is in pro-
gress.
Publicité
