Publicité
Les langues disponibles
Les langues disponibles
Congratulations on purchasing your
RF blink lamp . We hope it will give
you many years of reassuring opera-
tion. You have purchased a modern
and reliable system.
Please read through these operating
instructions carefully. They tell you
how to set up the system correctly
and explain all the system's features
to you.
Standard components
Please check if all following compo-
nents are included:
- RF blink lamp
- 9 V block battery
- 9 V plug-in PSU
- Stand
- Operating Instructions
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Functional principle
The RF blink lamp receives signals
from a variety of radio transmitters
and converts them into light signals.
The RF blink lamp has a very high-
power light-emitting diode (LED),
which brings a signal to the user's
attention, and additional LEDs which
indicate the nature of the incoming
signals.
Setting up the system
1a. Inserting the battery
There is a battery compartment on
the back of the RF blink lamp . Open
it by sliding the cover of the battery
compartment to the right of the recei-
ver using your thumb. Connect a 9 V
block battery to the connector plug,
insert the battery into the battery
compartment and close the device.
When the battery is connected, the
receiving signals may be triggered
once.
1b. Operation with a rechargeable
battery (A-2995-0)
The RF blink lamp can also be operated
using a rechargeable battery (A-2995-0),
which is available as a special acces-
sory. Open it by sliding the cover of
the battery compartment to the right
of the receiver using your thumb.
To connect the rechargeable battery,
insert the battery plug into the outlet
in the battery compartment.
English 11
Publicité
