Bourgeat NOMAD 886030 Notice D'utilisation Et D'entretien page 17

y Advanced settings : after pressing the corresponding key, access is granted to :
Advanced settings
Setting the fault cold temperature
Setting the cold fault :
The configurable value corresponds to the value starting at which you consider the cold to not be satisfactory for your use, if this is exceeded
for more than 10 mn, this fault will automatically be displayed on the screen and recorded for later viewing.
y Recording :
This traceability module provides access to the following functionality :
Fault recording
Fault recording :
Cold fault
Cold fault : this module allows a cold fault to be tripped if the fault temperature set by the manager (9° by default) is exceeded for more than
10 mn. No fault is recorded as long as the cold temperature setting is not reached.
These faults are then stored and can be consulted in the screen below :
Power fault : If there is en electric power fault while the equipment is operating, a fault is automatically recorded. These faults are then
stored and can be consulted in the screen below :
Bouton des enregistrements
Function active only in management mode
Power fault
17