Warnings - Angelcare AC401 Manuel De L'utilisateur

AC401 USA 3 langue JAN2010_AC401inter 042008 10-12-14 8:59 AM Page 5
• Route sensor pad cord only below crib matress
and out of reach of children.
• Use ONLY AAA (LR03) rechargeable
batteries and/or the AC adapters provided for the
Parents' Units.
• During long periods of non-use remove all
batteries from their compartments and unplug the
AC adapters.
• This monitor uses public airwaves to transmit
signals. The Parents' Unit may pick up signals or
interference from other nursery monitors in your area.
Your monitor may even be picked up by other
households. To protect your privacy, make sure both
units are turned off when not in use. If you experience
interference, change the channel on both units.
• When the monitor is in use, do not use a crib mobile
or other crib accessories that may produce vibrations.
Other sources of vibrations may include fans,
washing machines, loud music, etc. These sources of
vibration may interfere with the performance of your
Angelcare® monitor and the alarm will not sound if it
continues to detect any movement other than your
baby's. Be sure all vibration sources are eliminated
before using the monitor.
• You may experience false alarms for several
reasons. The most common reason is the Nursery
Unit has not been turned off after you have removed
your baby from the crib. Another reason is the Sensor
Pad has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with
the turquoise side facing up. The sensi-tivity level
may also need to be adjusted. Refer to the Movement
Sensitivity Adjustment section on P 9.
• Always be sure to immediately check on baby
whenever an alarm sounds.
• Your monitor can be used in any crib that is
stationary and designed to safely hold a baby. If your
crib has a spring or slat base you will need to place a
piece of Masonite board under the Sensor Pad. This
support must be at least 13 inches long on all four
sides and 1/4 inch thick. Only use your Angelcare®
monitor in a stationary sleeping environment such as
a crib where the Sensor Pad can rest on a completely
flat, firm surface.
WARNING
Modifications not authorized by the manufacturer
may void users authority to operate this device.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee thatinterference will
not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received,including interference that may cause
undesired operation.
5
reasonable protection
inaccordance with the