DHG SystemRoMedic Bure Standard/S Manuel D'utilisation page 6

3. Standing Up Using the Bure
With electrical components:
1. Ask the user to sit on the edge of the bed or chair. Bring out the walking table and place it in front of the user.
Lock the brakes on the wheels.
2. Ask the user to place their arms on the armrests. If necessary, ask the user to move forward on the seat base
so that the user reaches the handles.
3. Ask the user to lean forward. To start raising the walking table, press the UP button on the controller. Raise
the walking table to a desired height.
4. Unlock the brakes. Assist the user while walking.
With gas piston:
1. Ask the user to sit on the edge of the bed or chair. Bring out the walking table and place it in front of the user.
Lock the brakes on the wheels.
2. Raise the walking table by pressing the handle on the gas piston.
3. Ask the user to lean forward, grap the armrests and stand up.
4. Adjust the height of the walking table to a desired position
4. Using Bure Walker with Gait Training Kit 56-388
Back
• The gait support harness has four blue straps with a plastic buckle allowing for adjustments in length, having
steel carabiner clips at the ends to be fasten to the gait walker. The carabiner clips on to the metal mounts
placed under the table of the Gait walker.
• Apply the gait walker support harness by clipping on the two front carabiners to the front mounters, one on
each side of the table.
• Place the user standing up in the Gait walker. Pull back the harness in between the legs and clip on the
carabiners to the back mounters, one on each side of the table. Adjust the harness to the user by pulling in
the back strap loops.
• Observe! Intended use of the Gait trainer support harness is to practise walking. It is not a sitting or lifting
6
Top view
Front
aid.
I F U