Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
18 Adjustment of the release bar
for the release of the tab stop /
stop button
In case the tab stop / stop button
(28) does not trigger whilst you
move the hand lever (2) upwards
the release bar must be readjusted.
• Loose screws (32)
• Move screws downwards until
tab stop / stop button (28) trig-
gers whilst hand lever (2) moves
up
• Tighten screws (32)
32
19 Accessories
• Paper drill:
NAGEL paper drills with drill diame-
• Special cardboard 6970001
• Black drill insert 1933125
• Wax paper:
Frequent drilling of the wax paper
• Stop set collar 1933060:
For firm adjustment of drill positions
• Drill sharpener with sharpening
• Air cooling kit 1954583
20 Service
20.1 Maintenance of the machine
33
• Empty the cuttings box in good
• The black drill insert made out of
• Occasionally lightly oil the pas-
28
ters from 2-20 mm in different
qualities and usable lengths. Your
dealer will happily advise you.
greases the drill internally and
avoids breaking the drill.
on the stop rod.
stone
time, so that no blockage occurs
in the channel from paper slugs
backing up to the spindle. Other-
wise it blocks.
special plastic located in the slid-
ing table can be rotated and
turned. It should be changed
when it is so heavily drilled that
material to be drilled no longer
lays evenly.
sage of the spindle through the
casting guide (column guide,
spindle bearing).
Publicité
Table des Matières
