Assembly Of The Stand For Foot Operation (Special Equipment) - Nagel 190 A Mode D'emploi

14.1 Assembly of the stand for
foot operation (special equip-
ment)
• Unscrew the rear wall of the stand
(four screws).
• Remove the four rubber feet from
the drill.
• Lift the drill onto the stand
• Mount the drill from underneath
with four screws DIN 912
• CB 190, 290 remove the right
hand Perspex pane
• Connect the pressure rod (12)
which comes out of the foot stand
and lever (13) of the the drill by
using a cylinder screw (14) DIN
912 M8x40
• CB190 and 290 insert screw from
the right hand side through the
hole in the frame. Put the plain
washer in-between the machine
housing and the pressure rod,
see picture
• CB 190, 290 remount the right
hand Perspex pane
• CB 290B: Remove screw M5x50
from lever (13)
•
•
• Insert screw M8x40 from the left
side. Watch the washer.
• Mount sheet metal bracket with
trigger pin. Watch the washer.
Tighten screw from the left hand
machine side through the hole in
the frame.
13
14
• CB 190, 290, 290B screw
up the rear wall again.
12
21