Drill Depth Adjustment; Drill Depth Adjustment Citoborma 190; Drill Depth Adjustment Citoborma 290 And 290B - Nagel 190 A Mode D'emploi

Perforeuse de papier
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Taking out the chuck:
• To dismantle the chuck (19) take
off the union nut (17).
• Pull the chuck off the drill spindle
with the hook on the fork spanner
(16).
Always
keep
the
greased so that it can be taken out
easily.

15.2 Drill depth adjustment

Always take care!
Whenever the drill is changed and
always when the drill depth adjust-
ment is not known, the cutting
stroke must be carefully brought into
the highest position by turning the
hand wheel (8) the adjustment
screw (20) respectively to the right.
Otherwise there is a danger that the
cutting stroke is too large and be-
chuck
lightly
19
23
cause of this the drills drill into the
sliding table and break off.
15.2.1 Drill depth adjustment Ci-
toborma 190
• Lay the special cardboard on the
sliding table.
• Push the hand lever (2) down-
wards to lower the spindle.
• Turn the adjustment screw (20) to
the left until the drill leaves a
clearly visible impression on the
special cardboard.
15.2.2 Drill depth adjustment Ci-
toborma 290 and 290B
• Lay the special cardboard on the
sliding table.
• Push the hand lever (2) down-
wards to lower the spindle.
• Turn one of the two adjustment
screws (20) to the left.
• Also turn the other adjustment
screw to the left until the drills
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

290 a290 ab190290290 b

Table des Matières