Siemens TI921 Série Mode D'emploi page 33

Problem
The drip tray cannot be
removed.
The outlet system cannot be
assembled or disassembled.
Display shows "Fill bean con-
tainer". Displayed although the
bean container )B is already
full, or the grinder is not grind-
ing any coffee beans.
Display shows: "Empty drip
tray" even if the drip tray is
empty - what to do?
Display shows "Refill with still
water" or "Remove filter"
Very frequent display that des-
caling is necessary.
Display shows "Clean brewing
unit".
If you are unable to solve the problem, always call the hotline.
You will find the telephone numbers at the back of these instructions
--------
Cause
The coffee grounds container is
very full.
The coffee grounds slider is
stuck.
Incorrect sequence
Beans are not falling into the
grinding unit (beans too oily).
Emptying is not detected when
the appliance is switched off.
The drip tray is soiled.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Water is too hard.
Brewing unit soiled.
Too much ground coffee in the
brewing unit.
The brewing unit mechanism is
stiff.
Trouble shooting en
Solution
Clean the interior of the brewing unit.
~ "Cleaning the appliance"
on page 26
Correctly insert the coffee grounds
slider.
Connect the outlet system (with milk
system) first, then connect the milk
container. Alternatively, on disassem-
bly first remove the milk container and
then the outlet system.
Gently tap the bean container.Possibly
change the type of coffee. When the
bean container is empty, wipe it with a
dry cloth.
When the appliance is switched on,
remove and re-insert the drip tray.
Clean the drip tray thoroughly.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter in water until
no more air bubbles escape, then
insert the filter again.
Insert a new water filter.
Check whether the correct water hard-
ness is set in the menu. Insert water fil-
ter and activate according to the
instructions. ~ "Starting the "Water
filter"or "frost protection" programme"
on page 23
Clean the brewing unit.
Clean the brewing unit.Add no more
than 2 level measuring spoons of
ground coffee.
Clean the brewing unit. ~ "Daily care
and cleaning" on page 25
33