Siemens TI921 Série Mode D'emploi page 17

Notes
While milk is being prepared, you
■
may hear a whistling sound. These
noises are emitted for technical
reasons and are normal.
Dried milk residues are difficult to
■
remove so always perform cleaning.
~ "Cleaning the milk system"
on page 26
The quality of the milk froth depends
■
on the type of milk or the
plant-based alternative used.
:
Warning
Risk of burns!
The milk system becomes very hot.
After use, always let it cool down before
you touch it.
Using the milk container
The milk container H has been
designed especially for use together
with this appliance. It is intended solely
for use in the household and for storing
milk in the refrigerator.
Important: The milk container can only
be connected if the milk system is
installed in the outlet system with an
adapter and hose. (~ Fig. #)
To remove the lid, press the marking
1.
and remove the lid. (~ Fig. ')
Pour in the milk.
2.
Press the lid onto the milk container
3.
until it engages.
Connect the milk container on the
4.
left of the appliance. The milk
container must engage.
Coffee drinks with milk
The appliance is switched on. The water
tank and bean container have been
filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Use the rotary selector to select the
2.
desired drink.
Operating the appliance en
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink.
~ "Adjusting beverage settings"
on page 18 ~ "Settings"
on page 21
To begin dispensing the drink, press
4.
the rotary selector.
The milk is dispensed into the cup or
glass first. The coffee is then brewed
and dispensed into the cup or the glass.
Pressing the rotary selector once
Note:
can prematurely stop the dispensing of
milk or coffee; pressing the rotary
selector twice stops the drink
dispensing completely.
Milk froth or warm milk
The appliance is switched on. The water
tank has been filled.
The milk container filled with milk is
connected.
Place a cup or a glass under the
1.
outlet system.
Select "Milk froth" or "Warm milk"
2.
with the rotary selector.
The name of the drink and the currently
active values are shown on the display.
To change the settings for the
3.
selected drink.
~ "Adjusting beverage settings"
on page 18 ~ "Settings"
on page 21
To begin dispensing the drink, press
4.
the rotary selector.
Milk froth or warm milk is dispensed
into the cup or glass.
To prematurely stop dispensing
Note:
the drink, press the rotary selector
again.
17