MEDC PBE Manuel Technique page 5

MEDC recommend the use of stainless steel screws.
ccess to Terminals
Unscrew the 4 off M5 screws (4.0mm /F hexagon key) holding the lid to the base. The cover screws
are captive and should be retained in the cover.
Gently remove the cover assembly from the base of the enclosure. The cover assembly should remain
attached to the base by means of a retaining strap.
Once termination is complete, carefully replace the cover assembly back onto the base avoiding
damage to the mating surfaces. Ensure that the retaining strap is not trapped between the mating
surfaces and that the o-ring is correctly seated in its groove. Ensure the retaining strap and wires are
clear of the microswitch actuator and operating mechanism. Tighten the 4 off M5 screws (4.0mm /F
hexagon key) evenly.
BGE GENER L RR NGEMENT
BGE units - operation
The unit is operated by the breaking of the glass. Due to the design of the unit, there is no need to use a
hammer and the operator is protected from the broken glass by the vinyl glass label.
Replacement of the glass
To replace the glass after operation of the unit, remove the small outer cover held in place by the two off
slotted screws. Take out the glass and remove any broken fragments from the unit. Place the new glass
element into the unit and replace the cover, ensuring the 2 off slotted screws are tightened evenly.
Following replacement of the glass it is advised that the unit is tested using the procedure outlined below
Testing the unit
Using the test key provided, insert the key into the test hole (situated on bottom right hand side of the
glass cover) and engage into test cam. Turn the key in a clockwise direction (approximately 60°). This
will simulate the breaking of the glass. Release the key to reset the callpoint.
NOTE: MEDC DO NOT recommend forcing the test key further than 80° clockwise or 0° anti-
clockwise as this may lead to premature failure of the test cam.
11/13 © MEDC 2013