Remote Control Installation - Baxi Luna 3 Comfort Notice D'installation Et D'entretien

The remote control can be installed directly on the boiler or in the wall.
7.1 installing the remote control on the boiler front panel
To fit the remote control inside the boiler front control panel, proceed as
follows:
1. Undo the two screws (a-b figure 26) fixing the casing to the boiler;
. Lift the casing slightly and with one hand push the front panel cover on
the outside (figure 26);
3. Pass the blue wire, coming from the terminal block M (located behind
the casing), through the special hole in the remote control and cut it as
shown in figure 26.3)
4. Open the remote control (there are no screws) by prising with hands and
connect the red wire (figure 26.3);
Figure 6.1
5. Fit the remote control inside the special housing on the front control panel without forcing;
6. close the casing and fix it to the boiler with the screws (figure 26).
WarnInG: the remote control is a Low Tension appliance. Do not connect it to a 120 V power supply. For the electrical
connection refer to section 10.1 and 20.
paraMeter settInG
• set both "MoDul" and "aMBon" parameters = 0, as described in section 18.1;
• set F10 = 0 parameter as described in section 19.
°c/°F cHanGe MoDalItY
To change the unit of measurement from °c to °F and vice versa, see parameter "cH sl" described in section 18.1.
rooM tHerMostat connectIon
• Access the power supply terminal block (figure 23);
• connect the room thermostat cables to terminals (1) e (2);
• provide power supply to the boiler;
DescrIptIon oF Button
The button does not operate as described in section 4.1 of the instructions for the user (ECONOMY-COMFORT
function).
The gas boiler operates when both the programmed time slot and the room thermostat required heating.
By pressing the button during a room thermostat heating request, it is possible "to forced" a Heating request even if
the programmed time slot does not required Heating. This is a "manual forced" mode and the display shows the symbol
flashing. This mode terminates at the next "not request" time change over of the time slot Heating.
InstructIons pertaInInG to tHe Installer

7. remote control installation

Figure 6.
Figure 6.3
6
Figure 6
95.188.3 - GB