Opening/Closing The Enclosure Cover On The Evergum ® Distributor; Maintaining The Protection Class; That Will Be Connected; Plug Systems - Mennekes AMAXX Notice D'utilisation

6.5 Opening, closing the enclosure cover on
the EverGUM
®
b
4
a
3
Open the enclosure cover
Opening
• If present, remove the padlock (1) or the screw (2).
• Undo the quick-release fasteners (3) (a).
• Swing the enclosure cover (4) upward (b).
Closing
• Swing the enclosure cover (4) downward(b).
• Use the quick-release fasteners to lock the enclosure cover
(3) (a).
• Lock the enclosure cover with the padlock, if present (1),
or the screw (2).

6.6 Maintaining the protection class

The mobile receptacle combinations can be equipped on a
country specific basis with different attached receptacles,
and they can be designed in different protection classes
(e.g. IP 44 or IP 67).
To maintain the protection class of the device, only electri-
cal consumers of the same protection class design must be
combined and operated with the receptacle combination,
(example: Connect an IP 67 plug of a consumer to an IP 67
receptacle of the receptacle combination).
Information on the protection class of your receptacle
combination can be found in the "Technical Data" chapter
or on the rating plate of the device.
distributor
1
• Before use, check which protection class design
corresponds to the receptacle combination and the
consumers that will be connected.
• Connect consumers with the same protection class and
2
a suitable plug device to the device in order to avoid
reducing the effect of the protection class.
If a plug of protection class IP 44 is inserted into a
receptacle combination of protection class IP 67, the
receptacle combination only meets the requirements of
protection class IP 44!
Consequence: limited protection function!
Pay particular attention with IP 44 protection class
devices and when using the device outdoors.
6.7 Particularities concerning the consumers
to be connected
6.7.1

Plug systems

Attention
Material damage due to an unsuitable consumer
When connecting a consumer with unsuitable plug
connections fire can occur due to deficient contacting of
the components.
• Only connect consumers with suitable plug connections
on the device.
Consumers with Schuko
(IP 66, IP 68 / DWD) when plugged into IP 44 / IP 54
Schuko mobile receptacle combinations or couplings do
®
not achieve adequate contacting due to the design.
The same applies for AC adapters and right angle plugs.
These devices must not be operated together.
The Schuko receptacles and couplings in question are
®
marked indicated via a plug symbol (1) (see Fig.).
> IP 44 / IP 54 plugs
®
DE EN
EN EN
NL NL
FR FR
IT IT
11