Cleaning The Device; Device Inspection In A Non-Commercial Environment; Device Inspection In A Commercial Environment - Mennekes AMAXX Notice D'utilisation

Checking the residual current device (RCD)
• Actuate the test, button (T) (2).
The residual current device triggers (3) (click!)
• Return the triggering lever (1) to its initial position.
• If any faults occur during the checking, immediately
consult a qualified electrician.
• Do not continue to use the defective device.
9.1.4

Cleaning the device

• Regularly clean the device in order to prevent persistent
soiling on its surfaces.
Ö
Please refer to the "Cleaning" chapter
10. Maintenance
The activities described in this chapter may only
be carried out by a qualified electrician!
10.1 Device inspection in a non-commercial
environment
For long-lasting and safe operation we recommend that you
have have an electrician inspect the device for proper condi-
tion at regular intervals.
• Have an electrician inspect the device for proper condition
at regular intervals.
• Should damage to the device occur during its use contact
a qualified electrician.
• Have a qualified electrician rectify the damage without
delay.
• Comply with the applicable national statutory regulations
and provisions in the respective country of installation.
16
10.2 Device inspection in a commercial envi-
ronment
When using the device in a commercial environment, the
operator / user of the device must have a qualified electri-
cian check the proper condition of the device regularly.
Should damage to the device occur during its use, the
damage must be rectified immediately.
• Have an electrician inspect the device at regular intervals.
• Comply with the applicable national statutory regulations
and provisions in the respective country of installation.
Tasks to be executed by a qualified electrician
Danger
Risk of sustaining injury due to electric shock
Danger of severe or fatal injury when touching energized
components.
• Only execute tasks on the device after you have
disconnected it from the power supply and have
unplugged the power plug.
• Check the device for damage.
• Properly rectify any device damage.
• For repairs only use original spare parts from MENNEKES.
• After the repair check the device for proper function.
• If re-commissioning the device is not likely due to damage,
and with regard to further safe use, the device must no
longer be placed in service.