Checking The Connection Of The Supply Line; Closing The Device; Checking The Socket Connection - Mennekes 96438 Notice D'utilisation Et De Montage

• Tighten the cable gland (2).
• Remove the insulation from the individual wires.
• Connect the wires with the marked terminals (3).
• Check to ensure that all wire terminations and pre-wired
components in the device are firmly fitted.
• Tighten loose threaded connections as needed.

6.3.8 Checking the connection of the supply line

• Switch the power supply on.
• Check the voltage and the field of rotation of the supply
line at the device.

6.3.9 Closing the device

Closing the device by means of enclosure screws
The procedure is described in the example with hinged
enclosure cover. For some devices, a special key is required,
which is included in the scope of delivery.
1
2
Close the device by means of enclosure screws
• Swivel the upper enclosure section (1) shut.
• Tighten the enclosure screws (2).
Closing the device by means of special key
2
Closing the device by means of special key
• Insert the special key (1) into the interlocks (2) and turn it
clockwise.

6.3.10 Checking the socket connection

2
3
Checking the sockets
• Open the inspection window (1).
Ö
see page 15
• Activate the protective devices (2).
• Check the voltage on every socket (3).
EN EN
EN EN
1
NL NL
FR FR
IT IT
1
3
13