Residual Risks; Danger Due To Unsuitable Ambient Conditions; Danger Due To A Missing Fuse; Danger Due To Fire - Mennekes AMAXX Notice D'utilisation

Operation of the device under unsuitable ambient
conditions
• Only operate the device under the ambient conditions that
have been approved and are suitable for this.
Ö
Please refer to the "Technical Data" chapter
Climbing onto or sitting on the device
• Do not climb onto or sit on the device – danger of injury
due to falling and/or material damage to the device!

3. Residual Risks

3.1 Danger due to unsuitable ambient con-
ditions
Warning
Danger of injury due to unsuitable ambient condi-
tions
Use of the device under unsuitable ambient conditions
can result in device damage, which in turn can cause
injury through electric shock.
• Only use the device under suitable ambient conditions to
prevent the risk of an electric shock.
Ö
Please refer to the "Technical Data" chapter

3.2 Danger due to a missing fuse

Warning
Danger due to an unsuitable or missing fuse
When using a device outdoors with unsuitable fusing or
lack of fusing through a residual current device (RCD),
injuries due to electric shock can occur.
• Only use the device outdoors if the device or the
supplying receptacle is fused to a suitable residual
current device (RCD).
• Contact a qualified electrician if in doubt.
6

3.3 Danger due to fire

Warning
Risk of sustaining injury due to fire
Heat may build up within the receptacle combination if
the device is covered by an object; this can cause a fire.
• Never cover the device.
• Do not put objects on the device.

3.4 Danger due to improper operation

Warning
Risk of injury due to improper operation
Improper operation may cause damage to the device,
which may result in injuries.
• Always disconnect the plug by pulling at the plug
enclosing of the connected plug to remove it from the
socket.
• Ensure that the cables are not kinked, pinched or run
over, and will not make contact with external heat
sources.
• Do not connect any additional receptacle strips or
adapter plugs on the device.

3.5 Danger due to condensed water

Attention
Material damage due to condensed water
Under unfavourable ambient conditions condensation can
form in the interior of the device (particularly with protec-
tion class IP 67). In this case device damage can occur.
• Avoid significant temperature fluctuations, particularly
during operation.
• Only operate the device under suitable ambient
conditions.
Ö
Please refer to the "Technical Data" chapter