brennenstuhl MULTI 6050 MH Mode D'emploi page 10

Operating instructions
2
100% 75% 50% 25%
OPERATION OF THE HYBRID FLOODLIGHT WITH POWER SUPPLY
The floodlight can be connected to the power supply using the supplied plug-in cable via
the connection socket at the back side (Fig. 3).
To switch the floodlight on, operate the button on the back (Fig. 2).
Press the switch multiple times (Fig. 2) to set the brightness to 100%, then 75%, 50%, then
25% and then "off". Keep the button pressed (Fig. 2) to continuously reduce or increase the
brightness.
If the switch is left in any of its "on" positions for longer than 5 seconds, then pressing it
once again will always turn it off.
If the floodlight is connected to the mains, the rechargeable battery is not charged.
If the floodlight is connected to the power supply, the floodlight is operated with mains
voltage by default. In case of power failure or if the device is unplugged from the mains,
the floodlight will automatically switch to battery operation if a rechargeable battery with
sufficient charging is inserted into the battery holder. This is signalled by the floodlight
flashing three times.
CHARGING THE RECHARGEABLE BATTERY
Only use one of the manufacturer's original charging device: Bosch, Dewalt, Makita,
Metabo (CAS), Milwaukee.
TRIPOD MOUNTING
By means of the holes in the holding bracket, the floodlight can be mounted on a
Brennenstuhl tripod.
SCOPE OF DELIVERY
Floodlight, plug-in connection cable, 4 multi adapters: Bosch, Makita, Metabo,
Milwaukee/Dewalt, bag.
ACCESSORIES
Suitable accessories are available on our homepage www.brennenstuhl.com.
10
013721 BA_MULTI 6050 MH_6052 MH.indd 10 013721 BA_MULTI 6050 MH_6052 MH.indd 10
3
MULTI 6050 MH / MULTI 6052 MH
06.04.21 13:29 06.04.21 13:29