Scheppach HC 6 Traduction Du Manuel D'origine page 21

3 All accessories get connected to the adjustable drain
valve (8).
4 The pressure of the adjustable outlet can, as shown on
the manometer for reduced pressure (6), be changed
by turning the pressure reducer (7).
Attention: In order to be able to read the correct
pressure on the manometer, air must flow through the
outlet.
In order to increase the air pressure, turn the valve
clockwise. In order to reduce the air pressure, turn the
valve anti-clockwise.
Attention: The absence of air flow during setting produces
an incorrect display. For a correct display, air must flow.
5 Upon termination of your work, or when you leave the
compressor unattended, switch it off as follows:
• Press the ON/OFF switch (3) to O.
Maintenance
Fig. 2
1 After every operating day, drain the condensate from
the tank using the drain plug (10).
2 Daily check the function of the safety valve. When
checking, the tank must be at maximum pressure.
For checking the valve, set the tank under pressure and
pull the ring on the safety valve to the outside.
There should be air escaping from the valve.
At releasing the ring from the safety valve, the escaping
air must stop.
Warnings
For this test goggles must be worn. Do not hold your face
close to the safety valve as there the air escapes at a high
pressure.
Should the safety valve not work properly as described
above, immediately switch off the compressor and have
the safety valve examined by your dealer.
Do not work with the compressor when the safety valve
does not work properly, as described above.
General inspection
1 Regularly check all the fixing bolts for their tight seat.
2 Regularly check, at short intervals, the electric cable
for damages. A damaged cable must be replaced by an
electrician in order to avoid any danger.
Cleaning
1 Always keep the air inputs and outputs free and clean.
2 Regularly remove dust and dirt with a soft brush or a
soft cloth.
international 21