Scheppach HC 6 Traduction Du Manuel D'origine page 15

• Check the maximum admissible pressure of all devices
used with the compressor. The output pressure on the
compressor must be set in such a way that it never ex-
ceeds the prescribed pressure of devices or accessories.
• In order to reduce the risk of injury from moving parts,
never operate the compressor without the guard fitted.
Let hot components cool down before touching them.
• Read all labels and notes on the paint tank or on other
spray materials. Carefully observe all safety instruc-
tions. Wear a breathing mask when there is a risk of
inhaling spray materials. Carefully check the function
of the breathing mask before putting it on.
• Always wear goggles when handling the compressor.
Never direct the nozzle of an accessory towards your
body or towards another person.
• Do not try to adjust the pressure switch or the drain
valve underneath the pressure switch cover.
• Remove daily the liquid from the tank in order to avoid
corrosion.
• Keep the compressor at least 300 mm away from the
wall in order to ensure sufficient venting for the cooling.
• Before you transport the compressor, drain the com-
pressed air from the tank and secure the machine safe-
ly.
• Protect the air hose and the cable set from damage.
Regularly examine the components for weak and worn
spots, and replace them in case of need.
• Do not use an extension cable for this product. Use
instead an additional air hose in order to avoid a drop
in power and a possible motor damage. The use of an
extension cable makes the warranty invalid.
• After a long period of work, the outer metal parts can
get hot.
• Press the ON/OFF switch to switch off the compres-
sor. Only then cut the mains supply or pull the power
supply plug.
• After using the compressor, press the ON/OFF switch,
cut off the mains supply, and open the drain valve in
order to reduce the pressure.
• Do not try to remove a part from the machine while it
is pressurized.
• Wear safety gears including goggles or a screen, ear pro-
tection, breathing mask and protective clothing.
• After connection to the mains and switching on, the
machine starts automatically.
• Air escaping from the compressor may not be inhaled.
• Check the pressure control valve daily before starting
work.
• Drain humidity from the tank. Avoid tank corrosion.
• Cut off the mains supply, remove the power supply
plug, and relieve the pressure before starting mainte-
nance work.
Wear goggles.
Wear ear protection.
Wear a breathing mask.
Never direct the output air from the compressor towards
a part of the body or a person. Never try to block the air
escape with your finger or a part of your body.
international 15