Memory Capacity; Factory Reset - tau K995MA-S Notice D'installation

entered within 10 seconds the board exits the programming function);
3_ Press the button of the relative radio control device;
4_ The (green) DL2 LED turns off to indicate saving is complete and then on again immediately waiting
for other radio control devices (if this is not the case, try to re-transmit or wait 5 seconds and restart
from point 1);
5_ To memorise codes to other radio control devices, press the key to be stored on other devices
within 5 sec. After this time (green DL2 LED turns off) must repeat the procedure from point 1 (up
to a maximum of 30 transmitters);
Note: if the maximum number of codes (no. 30) is exceeded, the DL2 LED will start flashing quickly,
but without carrying out the memorization.
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ Keep button P1 pressed for 3 seconds in order to cancel all the associated radio control devices;
2_ (Green) DL2 LED flashes slowly to indicate that the cancellation mode has been activated;
3_ press button P1 again for 3 seconds;
4_ (Green) DL2 LED turns off for approx. 3 seconds and then remains steady to indicate that the code
has been cancelled;

MEMORY CAPACITY

The code memory capacity* of the D770M can be expanded from 30 to 126, 254 or 1022 codes (transmit-
ters) by replacing the memory cards as follows (plug them onto J3 connector, see wiring diagram):
126 codes
254 codes
1022 codes
* Control units are supplied with a standard built-in 30-code memory. The memory card for enhancing the
code memory capacity must be ordered separately.
To allow the previously stored codes (max. 30) to be moved to the control unit, it is required to install
a memory card, making sure that the control unit is at that time off and that the memory card is brand
new and therefore completely empty.
When the control unit is restarted, the codes will automatically move to the memory card.
Moving the codes from the control unit to the memory card does not work if on the memory card used,
radio control codes have already been stored and the memory card has been subsequently erased.
To insert new radio controls, the operation described above shall be repeated.
WARNING: Control unit must be turned OFF to insert / remove a memory card.

8. FACTORY RESET:

- With the voltage off, press and hold the P1 and P2 keys at the same time.
Power up the control board (by still pressing the P1 and P2 keys); the DL1 LED starts flashing red.
Release the keys and press them again until the LED switches off for 1 sec. confirming the end of
the procedure. Upon restarting, it will be necessary to carry out the memorization procedure
By carrying out a factory reset, the radio memory remains unchanged, therefore the
existing radio controls remain memorized.
9. LED DI DIAGNOSI
DL1 ERRORS red LED signal
Led indicating the programming of REMOTE CONTROLS and the status of the control
DL2
unit
DL3 BUS signaling yellow LED
DL4
SENSITIVE EDGE green LED signal
250SM126
Art.
Art. 250SM254
250SM1022
Art.
18
.